Technical highlights:

• Make sure the installation is performed by a trained professional.
• Schedule a maintenance plan to check tension on retainers and tighten bolts.
• Do not install solar panels higher than 6 meters. Check compatibility between solar cells and mounts.
• A stress analysis must be performed when placing an eccentric load on a tower. This can cause excessive torsion and bending of the tower, resulting in structural failure.
• Every dish antenna must have a radome as an accessory to reduce wind drag.
• The use of plates larger than 2 feet (60 cm) in diameter is not recommended in this tower (check with engineering).
• The declared weight is for the equipment without accessories and without packaging.
• The towers can be purchased in complete kits SEE TOWER KITS .

Warning:

• Hot-dip galvanizing is recommended for humid areas, salty and/or corrosive environments, industrial parks with gas release ( SEE AREA MAP ).
• The tower must be painted according to (at least) the CFE D8500-02 specification (7 symmetrical stripes of orange and white colors interspersed, starting and ending in orange.
• It must include night lighting, at least two luminaires, one in the middle and one at the top.
• Local regulations should be consulted according to the municipality to ensure proper and legal installation of the tower.
• We recommend at all times following the recommendations for installing the retainer: SEE THE RETAINER INSTALLATION DIAGRAM .