IRONCLAD Fence Sensor Cable, 305m Roll / Requires ELC2ZKIT

IRONCLAD Fence Sensor Cable, 305m Roll / Requires ELC2ZKIT

It is specifically designed for outdoor use.
The outer cover is made of a steel mesh armor as an integral and inseparable part of the cable.
305 meter roll

Requires the ELC2ZKIT analyzer unit

1 year warranty

IRONCLAD

Perimeter Security Made Easy, Reliable, and Affordable
The easiest and most reliable fence sensor cable you've ever installed!

• Plug and Play - Affordable, ready-to-install kits.
• 3 layers of false alarm filtration - Extremely low false alarm rate.
• Protects fences up to 10 feet high in a single cable run.
• No training or special tools required, comes with installation manual
• No calibration required - the system self-calibrates
• Maintenance-free - 2-year warranty on the sensor cable
• 22 Sensitivity levels per zone easily adjustable with DIP switches.
• Dry contact relay outputs (NO or NC) can be connected to any alarm/DVR system.
• Ideal for installation on chain link or serpentine coil fences.
• Frequently Asked Questions about Ironclad

Detect and stop intruders on the fence line

The Ironclad is a sensor cable attached to the fence to detect any cutting, climbing, lifting, or jumping over it. A single run of the cable through the center of the detection fence allows detection of the entire fence height, up to 10 feet, against any intrusion attempt.

Each processor can monitor up to 2 zones with 2 separate relay outputs per zone, zones are sold pre-cut in 250'/500'/1000' (75m/152m/305m).
The system has been designed to connect to any alarm system and is capable of adapting to old or new burglar alarm / DVR / NVR / SCADA systems.

Completely wrapped in a stainless steel braid, Ironclad is ideal for installation on wire fences, barbed wire, and concertina wire.

How does IRONCLAD detect intruders and not wind?

The system uses three layers of false alarm filtration. 1. The detection algorithm has been designed to detect only high-pitched vibrations at frequencies associated with intrusion attempts, while filtering out high-pitched weather frequencies. 2. 22 sensitivity levels per zone easily adjustable with DIP switches. 3. Weather station to prevent false alarms caused by weather conditions.

Get better perimeter protection for sites like the following:

• Commercial and industrial areas.
• Cars, RVs, boats or equipment from storage areas.
• Solar and wind farms.
• Water, electrical substations.
• Courtyards of large houses.
• Storage Locations.
• Radio, cell phone, communication antennas.

The fence alarm system sensor layout is:

1. The sensor cable is pre-cut into 250ft/75m, 500ft/152m and 1000ft/305m lengths.
2. Each processor (analyzer) can monitor up to 2 zones (reels)
3. Maximum length per processor is 2000ft / 600m of sensor cable, 2 zones of 1000ft / 305m
4. Each kit also includes: A processor in a weatherproof housing and a sensor cable of the selected length
5. To cover larger perimeters, there is the option of combining as many kits as necessary.

Frequently Asked Questions